What causes rising damp in Pretoria and Johannesburg homes?
Peeling paint just above the skirting is one of the most common reasons people look for a damp proof company. Sometimes it is rising damp, and sometimes it is something that only looks like it. This guide explains what causes rising damp, how it differs from other damp, and what to check before you book a survey.
Request a site surveyThe basics
What rising damp is
Brick, block and mortar are porous. Where a wall sits on damp ground, moisture can be drawn upwards through the masonry, much like water climbing up a paper towel. Walls are normally built with a damp proof course (DPC), a horizontal barrier near the base of the wall, to stop this. Rising damp happens when that barrier is missing, has failed, or has been bridged.
As the water evaporates from the wall, it leaves salts behind. Those salts are why rising damp often shows as white, fluffy deposits, bubbling paint and crumbling plaster in a band roughly up to a metre above the floor.
Common causes on the Highveld
- A bridged damp proof course. Paving, a raised flower bed or soil banked up against an outside wall can sit above the DPC, so moisture bypasses it.
- Plaster or render taken down to the ground. Plaster that runs past the DPC can draw moisture up the face of the wall.
- An older or damaged DPC. In older brick homes the DPC may be deteriorated, damaged by building work or ground movement, or absent.
- Wet ground next to the wall. Poorly draining paving, leaking garden taps and downpipes that discharge against the wall keep the base of the masonry wet, especially in the summer rainy season.
- Clay soils and movement. Expansive clay soils found in parts of Gauteng swell and shrink with the seasons, which can crack floors, paving and walls near ground level.
Not always rising damp
Problems that look similar
Not every low-level stain is rising damp. A survey should rule out the alternatives before recommending treatment.
Penetrating and lateral damp
Penetrating damp comes in through an exposed part of the building and often changes after rain. Lateral damp moves sideways where soil is higher on one side of a wall, such as a retaining wall or planter.
Leaks and condensation
A leaking pipe, shower or geyser connection can leave a very similar tide mark. Condensation in cold Highveld winters tends to show as mould in corners, behind furniture and around windows rather than as a band of salts.
Before you book
Simple checks you can make
Look at the outside of the affected wall. Is paving, soil or a planter higher than the inside floor level? Is a downpipe or tap discharging nearby? Note whether the mark is there all year or changes after rain, and take a wide photo and a close-up of the inside and outside of the wall.
How rising damp is treated
Treatment depends on what the survey finds. It may include lowering ground levels or paving, correcting drainage, rising damp treatment such as chemical damp proofing (a chemical DPC injected into suitable masonry), removing salt-damaged plaster, re-plastering and, once the wall has dried, painting. Read more about damp proofing or browse the damp proofing questions.
The Damp Proof Company works in Pretoria and Johannesburg. See damp proofing Pretoria or damp proofing Johannesburg, or request a site survey with your suburb and photos.